Goth
12/1/04 12:58:45 PM
Guru
|
1. You can remove the piezo, LED and switch. you can even cut the board - make sure it is below the group of thick traces that run most of the length of the board, about 10mm up along the longest axis.
Post a photo and i'll show you
Pin connections:
1: (Red stripe) DB7 (LPT 9)
2: DB6 (LPT 8)
3: DB5 (LPT 7)
4: DB4 (LPT 6)
5: DB3 (LPT 5)
6: DB2 (LPT 4)
7: DB1 (LPT 3)
8: DB0 (LPT 2)
11: Ground (0V)
12: 5V+
16: Enable - LPT pin 1
17: Register Select - LPT 16
9, 10, 13, 14, 15, 18, 19, 20
Not connected
Edited by Goth: 4/8/2004 5:28:00 PM -----
"Overclocking the processor is not recommended. It may result in a slower speed" Asus A7V333 manual - WTF?
laputan_machine@hotmailNOSPAM.com
G0t Tacho ? http://SMLITacho.cjb.net
YES, IT WORKS GREAT
|
derelict_frog
13/1/04 12:10:55 AM
Overlord
|
Are there any standards in parralel cable wire colors?, cause in stead of 4 clips like in the ocau diy tut, mine was filled with glue and the wores were in random directions and all differnet lenghts so i have no idea which wire is which and can't really find out, any ideas?, mabye i need a better cable! -----
Currenty Building: Watercooled! = Asus A7N8X-E/2500-DangerDenMaze3/2x512 DDR400 Corsair XMS/80G & 120G Cuda's/Leadtek FX5950 Ultra 256MB-Jaron Refriderator/Audigy 2/Logitech Z-640/Antec TruePower 480W
http://www.derelictfrog.netfirms.com
|
Goth
13/1/04 10:27:00 AM
Guru
|
If you get the oatley electronics one, you get a very generous (close to 1m) 20-way IDC cable, with heatshrink over it, so you can just chop that and solder a D25 male connector onto it. There aren't really any colour standards, it is easiest to just grab some ribbon cable and a new D25 plug -----
"Overclocking the processor is not recommended. It may result in a slower speed" Asus A7V333 manual - WTF?
laputan_machine@hotmailNOSPAM.com
G0t Tacho ? http://SMLITacho.cjb.net
YES, IT WORKS GREAT
|
P.YO
13/1/04 10:56:24 AM
Overlord
|
or u can pull out the trust dmm and trace each wire to it's corresponding pin :P -----
(Desktop) ASUS P4B, P4 1.9Ghz, 256Mb Kingmax, ASUS GeForce 7100, 40Gb IBM HDD, SoundBlaster Live!, Sony 40x12x48 CDRW, Sony 16x DVD, LCD Display Thingy
(Lappy) P4 2Ghz, 256Mb RAM, 20Gb HDD, DVD/Burner Combo, Radeon 7500, 3DMark2001 SE 6131
|
derelict_frog
13/1/04 12:16:29 PM
Overlord
|
yeah, thats what im thinking, but its all glued together and the inside is a blob of glue, it wont work, grrrrr.
Un less i cut both ends off then solder them back on again! -----
Currenty Building: Watercooled! = Asus A7N8X-E/2500-DangerDenMaze3/2x512 DDR400 Corsair XMS/80G & 120G Cuda's/Leadtek FX5950 Ultra 256MB-Jaron Refriderator/Audigy 2/Logitech Z-640/Antec TruePower 480W
http://www.derelictfrog.netfirms.com
|
Goth
13/1/04 12:43:17 PM
Guru
|
Cut off 1 end and use a multimeter to match the wires to the pins on the parallel port plug -----
"Overclocking the processor is not recommended. It may result in a slower speed" Asus A7V333 manual - WTF?
laputan_machine@hotmailNOSPAM.com
G0t Tacho ? http://SMLITacho.cjb.net
YES, IT WORKS GREAT
|
derelict_frog
13/1/04 11:52:28 PM
Overlord
|
How does that work? Please explain! -----
Currenty Building: Watercooled! = Asus A7N8X-E/2500-DangerDenMaze3/2x512 DDR400 Corsair XMS/80G & 120G Cuda's/Leadtek FX5950 Ultra 256MB-Jaron Refriderator/Audigy 2/Logitech Z-640/Antec TruePower 480W
http://www.derelictfrog.netfirms.com
|
Goth
14/1/04 11:46:09 AM
Guru
|
Most multimeters have a continuity setting, when you have a valid connection it beeps.
Or if your meter doesn't, just use a resistance measurement. practically 0 Ohms, you've got the matching wire. -----
"Overclocking the processor is not recommended. It may result in a slower speed" Asus A7V333 manual - WTF?
laputan_machine@hotmailNOSPAM.com
G0t Tacho ? http://SMLITacho.cjb.net
YES, IT WORKS GREAT
|
derelict_frog
14/1/04 05:01:11 PM
Overlord
|
Ok thanks, don't actually have one but could be a good investment! -----
Currenty Building: Watercooled! = Asus A7N8X-E/2500-DangerDenMaze3/2x512 DDR400 Corsair XMS/80G & 120G Cuda's/Leadtek FX5950 Ultra 256MB-Jaron Refriderator/Audigy 2/Logitech Z-640/Antec TruePower 480W
http://www.derelictfrog.netfirms.com
|
Goth
15/1/04 02:54:11 PM
Guru
|
A basic one will only cost $10 -----
"Overclocking the processor is not recommended. It may result in a slower speed" Asus A7V333 manual - WTF?
laputan_machine@hotmailNOSPAM.com
G0t Tacho ? http://SMLITacho.cjb.net
YES, IT WORKS GREAT
|
OwenTheGreat
15/1/04 03:35:31 PM
Champion
|
Avoid these ones. Them(they?) or their very very slight varients can be purchased just about anythere, I had 3, the second one still kinda works.
http://www1.jaycar.com.au/products_uploaded/productLarge_5283.jpg
[EDIT]
Edited Grammer, but not very well :(
[EDIT2]
Changed link
Edited by OwenTheGreat: 16/1/2004 6:26:08 PM -----
Hello and welcome.
Please make note of the emergency exits, they are marked, "SPAM", "Abuse" and "If you don't like it leave!"
|
Goth
15/1/04 06:22:42 PM
Guru
|
I've never had one of them, if you get a reasonably good one it will last just about forever (7 years and counting, $50 when purchased, it doesn't have any fancy features though)
Except i've been through a set of test leads
Jaycar has a good range, you don't have to pay a fortune for a good one, and you don't need a fancy one for basic modding work -----
"Overclocking the processor is not recommended. It may result in a slower speed" Asus A7V333 manual - WTF?
laputan_machine@hotmailNOSPAM.com
G0t Tacho ? http://SMLITacho.cjb.net
YES, IT WORKS GREAT
|
derelict_frog
15/1/04 11:49:34 PM
Overlord
|
Thanks guys might get one next trip to jaycar. -----
Currenty Building: Watercooled! = Asus A7N8X-E/2500-DangerDenMaze3/2x512 DDR400 Corsair XMS/80G & 120G Cuda's/Leadtek FX5950 Ultra 256MB-Jaron Refriderator/Audigy 2/Logitech Z-640/Antec TruePower 480W
http://www.derelictfrog.netfirms.com
|
Tin Reaper
15/1/04 11:58:43 PM
Hero
Guru
|
owen: you know the dse site dosn't alow direct linking into the depths of their site and all it dose is throw you to the home page -----
Do not store near fruit, vegetables or smallgoods.
May contain traces of nuts.
Beware. i have a black belt in stating the bloody obvious.
|
Goth
16/1/04 09:33:18 AM
Guru
|
It worked for me
$30 will get you a fairly good one with Temp probe and backlight screen -----
"Overclocking the processor is not recommended. It may result in a slower speed" Asus A7V333 manual - WTF?
laputan_machine@hotmailNOSPAM.com
G0t Tacho ? http://SMLITacho.cjb.net
YES, IT WORKS GREAT
|
. This material may not be published, broadcast, rewritten or redistributed in any form without prior authorisation.